Add Papers Marked0
Paper checked off!

Marked works

Viewed0

Viewed works

Shopping Cart0
Paper added to shopping cart!

Shopping Cart

Register Now

internet library
Atlants.lv library
FAQ
4,99 € Add to cart
Add to Wish List
Want cheaper?
ID number:213622
 
Evaluation:
Published: 27.09.2010.
Language: English
Level: College/University
Literature: 14 units
References: Not used
Time period viewed: 2000 - 2010 years
Table of contents
Nr. Chapter  Page.
1.  Introduction    5
2.1.  Background    6
2.2.  Task    6
3 .  Research    7
3.1.1.  Microchip PIC    8
3.1.2.  PIC18F452    9
3.1.3.  Compiler    10
3.1.4.  PIC18F46K20    11
3.2.  Starting with compiler    12
3.2.1.  Programming    12
3.3.  Ultrasonic Transducer choice    14
4.  Circuit design    15
4.1.  Ultrasonic part of circuit    15
4.1.1.  Schematic of circuit    16
4.1.2.  Soldering    17
4.2.  RFID part of circuit    19
4.2.1.  Schematic of circuit    20
4.2.2.  Attaching microcontroller    21
4.2.3.  Soldering    22
4.3.  Building coil    24
5.  Conclusion    25
6.  References    26
Extract

5 Conclusion
The project started with studies. Before building prototype, it is necessary to understand, how system is working, what is it minors and advantages, choose the cheapest way of building, and make prototype small and easy in use.
Microcontroller is a small computer on a single integrated circuit. Microcontrollers have great variety, from small timer chip to personnel microprocessors. After several weeks of exploring microcontrollers structure and usage, choice of PIC was the most advantageously. It cost and parameters gave complete sight. Difficulties of choosing microcontroller were, because manufacture has wide range of chips.
Exploring RFID systems had problems from the beginning. RFID circuits for location detection inside the aircraft are completely new technology. All information about RFID systems were based on few sources.
Base for designing circuit was found in internet. In these circuits were made only several changes, what made circuit cheaper or more powerful, according to the aims of project. Circuit is shown in the report in electronic format, as well as drawn on paper. Circuit model was successfully simulated in Multisim 11 program.
Hardware for circuits was bought from electronics shop. Problems with soldering took much more time, as planned, because there also were problems with equipment.

Author's comment
Load more similar papers

Atlants

Choose Authorization Method

Email & Password

Email & Password

Wrong e-mail adress or password!
Log In

Forgot your password?

Draugiem.pase
Facebook

Not registered yet?

Register and redeem free papers!

To receive free papers from Atlants.com it is necessary to register. It's quick and will only take a few seconds.

If you have already registered, simply to access the free content.

Cancel Register